Cranking pulse
MessagePosté :19 nov. 2011 00:01
Bonjour à tous 
De quel ordre de grandeur faut-il enrichir pendant la phase de demarrage ?
dans l'aide il ya :
The cranking pulse width at -40°F should be about 3 to 5 times the 170°F value. To begin, set the -40°F cranking pulse width to about 88% of your "upper" req_fuel value, and the 170°F cranking pulse width to about 23% of your req_fuel. Those should get you 'in the ball park' for starting. (Once you have the engine running, you can tune the cranking pulse widths with small changes, moving them up or down together, and check it over a few days worth of starts before deciding which direction to go next.
donc sur des temperature "moyenne" ,cela fait du 50% en plus au req_fuel ? donc 150% sur l'axe pw% de la courbe ?
De quel ordre de grandeur faut-il enrichir pendant la phase de demarrage ?
dans l'aide il ya :
The cranking pulse width at -40°F should be about 3 to 5 times the 170°F value. To begin, set the -40°F cranking pulse width to about 88% of your "upper" req_fuel value, and the 170°F cranking pulse width to about 23% of your req_fuel. Those should get you 'in the ball park' for starting. (Once you have the engine running, you can tune the cranking pulse widths with small changes, moving them up or down together, and check it over a few days worth of starts before deciding which direction to go next.
donc sur des temperature "moyenne" ,cela fait du 50% en plus au req_fuel ? donc 150% sur l'axe pw% de la courbe ?
